LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (0X - Complete Vehicle - General) >> WM 0X03IN Running Gear Maintenance: Axle Joints/Drive Shafts (Except Cayenne GTS Tip "PORSCHE Design Edition 3") >> Checking >> Tie Rod Joints: Checking Play And Dust Boots

Tie Rod Joints: Checking Play And Dust Boots

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lift vehicle → WM 4000V0 Lifting the vehicle .

    Information 

    • The rubber dust boots and bellows on the steering gear and on the tie rods can be damaged by external influences, e.g. stone impact, or during assembly work. 
    • If a rubber dust boot leaks, the joint or tie rod must be replaced, because any dirt or moisture that seeps in will destroy the joint. 
  2. Check play and dust boots.
  3. Check that dust boots, bellows and joints are functioning correctly and not leaking.