Pre-Treating Bonded Flanges On The Vehicle Body
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The table below shows how to use cleaners, primers and activators when preparing the bonding surfaces.
| Prepare vehicle window flange for installation | |
|---|---|
| Old flange (old paint) | New flange (new paint) |
| Cut back adhesive bead? | Cleaner ? |
| Clean flange surface? | |
| Activator ? | Primer ? |
| Activate adhesive bead (only necessary after standing times > 24 h) ↓ |
Prime flange surface? |
| Apply adhesive | |
| Install glass | |