Protective Measures And Rules Of Behavior

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Protective measures and rules of behavior

Assembly work only by trained staff.

Carry out tests only using the PIWIS Tester II 9818 diagnosis unit; do not use test lamps, voltmeters or ohmmeters.

Avoid contact with grease, solvents, cleaning agents or liquids.

Do not expose to temperatures above 90 °C.

Keep the deployment area of the blow-out opening clear; e.g. do not hang test devices over the steering wheel. When carrying the airbag, hold it with the blow-out opening facing away from the body. Set the airbag unit down with the blow-out opening facing upwards.

Electrostatic charge: In general, wear appropriate work clothing and footwear.

Do not remove the short-circuit spring of the plug contacts.

An airbag unit must never be connected incorrectly to electrical power sources (danger of ignition). Only use testers prescribed by the manufacturer.

During installation/removal or work on the vehicle involving vibrations: switch off ignition, disconnect and cover the negative terminal of the battery, wait 1 minute and only then should you disconnect the plug connection.

Transport: In transport packaging. Never in the passenger compartment!

Storage in the workshop: Max. 10 kg (=> 100 driver or 50 passenger airbags); protect against theft!

The airbag/seat-belt pretensioner unit must be installed immediately after removal from the transport container.

If work is interrupted, the airbag/seat-belt pretensioner unit must be stored in the transport container again.

Never leave the airbag/seat-belt pretensioner unit unattended.