LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 258 (5X - Body - General -- 92A Cayenne) >> WM 5X00IN Working With Body Structural Adhesive (Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne (3.0)) >> Working With Adhesives >> Joining Process >> Applying Adhesive

Applying Adhesive

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Apply a bead of adhesive to the flanges of the joint.

The thickness of the layer of adhesive after joining must not exceed → Layer thickness: 1 mm  ; spread the adhesive out on the bonding surface using a spatula if necessary.

Areas not covered by cathodic immersion paint and exposed body panels in cavities must be brushed or filled with structural adhesive.

scientia non olet · About LEMON Manuals