General Information
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Toxic substances
- Danger of poisoning or suffocation
- Danger of burns to the eyes and skin
→ Ventilate the work area well.
→ Never ingest or inhale.
→ Read specific information on the Hazard Sheet.
→ Do not smoke, eat or drink in the work area.
Information
- The vehicle, components and adhesives must be brought to processing temperature (acclimatised) before getting started. Processing temperature must be maintained for approx. 30 minutes before starting to work on the bonding surfaces.
- Bonding surfaces must be free from oil, old adhesive, dirt, moisture, and layers of paint and oxide.
- Body structural adhesive and primer must only be used on bare metal parts.
- Only use abrasive products based on pure silicon carbide (SIC) for sanding/grinding down the bonding area until bare.
- Always wear clean gloves when touching the cleaned surfaces to ensure that no sweat from your hands or dirt is transferred onto the bonding surface.
- Apply primer within 5 minutes on bare surfaces, particularly on aluminum components. Work in sections on large components and carry out intermediate sanding.
- The jointing operation must take place directly after application of the adhesive in order to guarantee a high quality and reliable bond. Otherwise the adhesive bead must be removed, with pre-treatment of the surface and application of the adhesive being repeated.
- After adhesive has hardened, carefully prime accessible bonding areas and seal with body sealant. Protect bonding areas in cavities against corrosion using cavity preservation.
Information
- To check that the substance is completely mixed, apply a 30-mm long bead of fresh adhesive to a piece of cardboard before processing.
- Process the adhesive within the processing time. The adhesive must be applied and the body part must be joined within this time period. Any resistance welding or mechanical joining procedures (e.g. riveting, screwing) to be carried out in the bonding area must also be performed within this time period.
- Do not put pressure on bonded parts until hardening is complete!
- If the contents of the cartridge is not used up completely, the processing nozzle must be left on the cartridge until the adhesive hardens. If you intend to use the adhesive again later, a new processing nozzle must be used.
Information
During cold periods, overnight or in cold countries, appropriate steps must be taken to ensure that the minimum hardening temperature is reached.
- Optimize heating system settings, e.g. deactivate night-time lowering of temperature.
- Keep doors and windows closed; avoid draughts.
- Install auxiliary heaters in the body repair area.
Information
- In addition to this manual, observe the relevant job descriptions for body repairs!
Information
Infrared heaters only heat small sections of the body and are therefore only suitable for minor repairs.
- Only use devices with temperature control, automatic distance measurement and measuring point display, e.g. infrared heater WE xxxx or infrared heater WE xxxx.