LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (69 Occupant Protection/Personal Protection -- 92A Cayenne) >> WM 691219 Removing And Installing Rear Three-Point Belt >> Subsequent Work >> Subsequent Work For Removing And Installing Rear Three-Point Belt At The Left And Right

Subsequent Work For Removing And Installing Rear Three-Point Belt At The Left And Right

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install side trim panel for rear luggage compartment. → INSTALLING SIDE TRIM PANEL FOR REAR LUGGAGE COMPARTMENT - section on "Installing"
  2. Perform a function test.
    • The belt strap must be fully rolled up when the function test is started.
    • Move the seat-belt height adjustment to the highest position.
    • Pull out the belt strap completely as far as it will go.
    • Roll up the belt strap again slowly. An audible buzzing noise can be heard when you do this.
    • If the roll-up process is interrupted, the belt strap cannot be pulled out again (permanent belt blockage).
    • The permanent belt blockage feature must be disabled at least 100 mm before the belt strap is completely rolled up in order to ensure that the belt strap can be pulled out again.
scientia non olet · About LEMON Manuals