LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 254 (91 - Radio, Stereo, Telephone, On-Board Computer -- 92A Cayenne) >> WM 916255 Replacing Control Unit For Steering Wheel Electronics (Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S Hybrid, Cayenne Turbo, Cayenne S Diesel, Cayenne (3.0)) >> Enabling Functions

Enabling Functions

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information 

On vehicles with the equipment variant heated steering wheel, multi-function steering wheel, cruise control or on-board computer, a function enable process must be carried out after replacing the steering wheel electronics control unit.

  1. Determine function enabling code in PIWIS.
  2. Connect the PIWIS Tester to the vehicle and start the PIWIS Tester. Switch on ignition.
  3. Select the vehicle type and start the diagnostic application.
  4. Select Steering wheel electronics  using the cursor keys and press [F12] to continue.
  5. Maintenance/repairs  must now be selected.
  6. Select Function enable  using the cursor keys and press [F12] to continue.
  7. Select the function, enter the function enabling code and press [F8] to save your entries.
  8. Repeat the process for other functions.
  9. Read out the fault memory and erase it if necessary.
  10. Function test: Perform a test drive.
  11. Read out the fault memory.
scientia non olet · About LEMON Manuals