LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (53 - Body Rear - 92A Cayenne) >> WM 535655 Replacing Side Panel Bottom Section >> Preparing Side Panel Bottom Section For Installation

Preparing Side Panel Bottom Section For Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make holes for plug-welding with inert gas using a body hole punch.
    Fig 1: Identifying Side Panel Bottom Section Holes For Plug-Welding
    G09939149Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Grind both sides of the connecting flanges of the side panel bottom section in the marked areas until bare.
    Fig 2: Identifying Connecting Flanges Of Side Panel Bottom Section
    G09939150Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Information 

    Do not apply zinc powder paint to the bonding areas.

  3. Coat all spot-weld flange areas with zinc powder paint.
scientia non olet · About LEMON Manuals