LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (42 Rear Wheel Suspension, Drive Shafts -- 92A Cayenne) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Wheel Carrier) (Except Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne S Diesel, Cayenne (3.0)) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the brake shoes to their basic setting and calibrate the electric parking brake actuators. → 468316 ADJUSTING AND CALIBRATING PARKING-BRAKE SHOES
  2. Connect the level sensor to the front upper wishbone. → 431955 REPLACING REAR LEVEL SENSOR

    Make sure that the level sensor linkage is facing outwards.

  3. Fit the wheel. → 440519 REMOVING AND INSTALLING WHEEL
  4. Tighten axle nut (drive shaft mounting on wheel side) (2-step tightening procedure!). Operate the brake while doing this (2 mechanics required). → 4X00IN TIGHTENING TORQUES FOR REAR AXLE
  5. For vehicles with air suspension: 

    Fill the air springs. → 4301IN BLEEDING AND FILLING THE LEVELLING SYSTEM

  6. Perform suspension alignment. → Suspension alignment, complete 
scientia non olet · About LEMON Manuals