LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (42 Rear Wheel Suspension, Drive Shafts -- 92A Cayenne) >> WM 422119 Removing And Installing Rear Drive Shaft (Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne S Diesel, Cayenne (3.0)) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move electric parking brake (EPB) into >>installation position<< using the Porsche System Tester. To do this, select >>Parking brake<< in the control unit overview. Select >>Drive links/checks<< >>All<< >>Move to installation position<<.
  2. Loosen the axle nut (drive shaft mounting on wheel side). (Do not remove it!) This prevents the drive shaft from slipping out when removing the wheel bearing housing. Actuate the brake while doing this.
  3. Remove wheel. → 440519 REMOVING AND INSTALLING WHEEL
  4. Remove rear level sensor from the front upper wishbone. → 431955 REPLACING REAR LEVEL SENSOR
scientia non olet · About LEMON Manuals