Installing Fuel Supply Line: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The description applies to all engine types .
- The setup and procedures required may differ slightly from the illustrations or procedures described due to engine-specific differences .
- The fuel supply line is installed in reverse order to removal.
- Tighten fastening screws on restraining straps to → Tightening torque: 23 Nm (17 ft. lb.) .
- Tighten three M6 collar nuts to → Tightening torque: 10 Nm (7.5 ft. lb.) and one M6 fastening screw to → Tightening torque: 10 Nm (7.5 ft. lb.) .
- Tighten two fastening screws for the heat shield on the cardan shaft to → Tightening torque: 10 Nm (7.5 ft. lb.) and one collar nut for the heat shield on the cardan shaft to → Tightening torque: 20 Nm (15 ft. lb.) .