Installing Boost Pressure Sensor
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
For tightening torques, tightening sequence and assembly overview, see → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS
Information
Replace sealing ring.
- Installation is performed in reverse order.
Information
For tightening torques, tightening sequence and assembly overview, see → 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1. The self-locking screws and O-ring must be replaced.
- 1.2. Before installation, remove all residual sealant from the threaded bores for the boost pressure sensor in the compressor housing using a thread cutter.