LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (27 - Starter, Power Supply, Cruise Control -- 92A Cayenne) >> WM 278519 Removing And Installing Control Unit For Distance Measuring Sensor (All Models) >> Installing Control Unit For Distance Measuring Sensor

Installing Control Unit For Distance Measuring Sensor

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order to removal.

    Information 

    Before and after fitting the trim cover for the distance measuring sensor control unit, check the following points:

    • The holder for the distance measuring sensor control unit must not show any signs of deformation, which may have been caused, for example, by removing or installing the trim cover for the distance measuring sensor control unit. If the holder for the distance measuring sensor control unit is deformed, carefully push it back into shape  .
    • If the trim cover is damaged or cracked, replace the trim cover  .
    • After fitting the trim cover, check that it is seated correctly and securely  .

    Tighten fastening screws. Tightening Torque 8 Nm (6 ft. lb.) 

scientia non olet · About LEMON Manuals