LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (39 - Final Drive - Differential, Differential Lock -- 92A Cayenne) >> WM 393519 Removing And Installing Rear CARDAN Shaft (All Models) >> Installing Rear Cardan Shaft

Installing Rear Cardan Shaft

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Tightening torque, tightening sequence and assembly overview. → 3X00IN TIGHTENING TORQUE, TIGHTENING SEQUENCE AND ASSEMBLY OVERVIEW

Information 

The circlips on the transmission journal must always be replaced. These must be pressed on radially.

  1. Always replace the circlip on the transfer gear journal and rear final drive. This must be pressed on radially.
  2. Fit the cardan shaft with the help of a second mechanic and screw on the center bearing.
  3. Turn the cardan shaft to the previously made marks and fit it onto the journal by jerking it but without tilting the cardan shaft.
  4. Check that the cardan shaft is fitted securely by pulling on it with your hand. Then press on the shaft again in the direction of the transmission journal.
    1. 4.1. If the cardan shaft comes off when you pull it, the circlips will need to be replaced again.
  5. Further assembly is carried out in reverse order to removal.
scientia non olet · About LEMON Manuals