Installing Oxygen Sensor
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Incorrect handling of oxygen sensors
- Damage to oxygen sensors
- Different exhaust emission behavior
→ Do not remove the plastic cap on the thread until just prior to fitting.
→ Protect oxygen sensors from impact of any kind.
→ Do not kink or twist the cables when screwing in the sensors.
→ Do not re-use dirty or damaged components.
Information
The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1. Coat oxygen sensor thread with assembly grease 000.043.207.07.
- 1.2. Tightening Torque: Tightening Torque 55 Nm (41 ft. lb.)
- 1.3. Replace tie-wrap.