LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (19 - Engine - Cooling -- 92A Cayenne) >> WM 196120 Removing And Installing Coolant Pipes (Cayenne S E-Hybrid) >> Removing And Installing Upper Coolant Pipe >> Installing Upper Coolant Pipe

Installing Upper Coolant Pipe

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Leaking fuel supply lines
  • Emerging fuel
  • Risk of fire

→ Perform leak test.

Information 

For Tightening Torques, tightening sequence and assembly overview, see → 1001IN Tightening TorqueS, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS

  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1. Replace O-rings.
    2. 1.2. Secure all hose connections with standard hose clamps.
    3. 1.3. Before installation, clean or smoothen the sealing face for the O-ring.
    4. 1.4. Moisten the O-ring with coolant and slide it onto the coolant pipe.
  2. Install lower part of intake manifold at the right. → 244719 REMOVING AND INSTALLING INTAKE MANIFOLD
  3. Install compressor. → 211419 REMOVING AND INSTALLING COMPRESSOR
  4. Fill in coolant. → 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING) 
scientia non olet · About LEMON Manuals