LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (19 - Engine - Cooling -- 92A Cayenne) >> WM 195019 Removing And Installing Coolant Pump (Cayenne S Hybrid, Cayenne Tip (3.0), Cayenne Tip "Platinum Edition" & Cayenne Tip (3.0) "Platinum Edition") >> Installing Coolant Pump

Installing Coolant Pump

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information 

For Tightening Torques, tightening sequence and assembly overview, see → 1001IN Tightening TorqueS, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS

  1. Installation is performed in reverse order. Pay particular attention to the following:

Information 

If you intend to re-install the previously used coolant pump, a bead of sealant measuring about 1.5 mm thick must be applied to the cleaned sealing face in addition to the vulcanized seal.

Clean sealing faces to remove any oil and grease.

scientia non olet · About LEMON Manuals