Removing And Installing Valve Block
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Escaping residual air
- Risk of eye injuries
→ Wear protective goggles.
Information
- Install in reverse order .
- The air lines are colored and designated with letters .
- Pay attention to cleanliness, if necessary clean the screw connections of the air lines with a lint-free cloth .
- Visually inspect all parts .
- Replace locking screws and nuts .
- Pay attention to tightening torques → see " TECHNICAL VALUES " .
- To fill the level adjustment system, use the Porsche System Tester. To do this, in the system >> Level adjustment >> select the menu item >> Fill <<; then fill the front and rear axles and the accumulator. Switch on level adjustment → (see SWITCHING ON LEVEL ADJUSTMENT ).
- Disconnect compressor from valve unit:
- Release tie-wrap and attachment at support
- Unclip air line and remove
- Remove compressor from support.
- Assembly is carried out in reverse order. Visually inspect all parts closely and replace defective parts if necessary.