LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (2X - Petrol, Exhaust, Engine-Electronic - General) >> WM 2X00IN Important Information On Adapting The DME Control Unit (Except Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne S Hybrid, Cayenne (3.0)) >> Writing Adaptation Values (Following Deletion) >> Sensor Wheel Adaptation

Sensor Wheel Adaptation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Necessary after: 

Necessary before: 

How? 

  1. Drive with engine overrun:
    1. 1.1. Meet preconditions:
      1. 1.1.1. Engine at operating temperature.
    2. 1.2. Accelerate to 3, 000 rpm (U /Min ) three times in quick succession in 2nd gear and allow vehicle to roll with gear engaged (engine overrun).

      Information 

      1. Adaptation values are deleted or stored in EEPROM when ignition is switched off after control unit run-on has ended.

      (Run-on period: 1 minute when engine is cold; up to 45 minutes when engine is hot)

    3. 1.3. Switch off ignition.
scientia non olet · About LEMON Manuals