LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (46 Brakes - Brake Mechanism -- 92A Cayenne) >> WM 468519 Removing And Installing Spreader Device (EPB) >> Subsequent Work >> Subsequent Work For Removing And Installing Spreader Device (EPB)

Subsequent Work For Removing And Installing Spreader Device (EPB)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information 

If new brake discs and/or new brake shoes are installed on the vehicle, they must be worn in before calibration (not PCCB!). → 468350 REWORKING PARKING-BRAKE SHOES 

If a new actuator was installed, it must be confirmed in the Porsche System Tester.

  1. Install brake shoes. → 468356 REPLACING BRAKE SHOES  - section on "Installing"
  2. Fit the brake calliper. → INSTALLING REAR BRAKE CALLIPER - section on "Installing"
  3. Fit wheel. → INSTALLING WHEEL - section on "Installing"
  4. Adjust, grind down and calibrate the electric parking brake (EPB) using the Porsche System Tester. → 468316 ADJUSTING PARKING-BRAKE SHOES  → - section on "Installing"