Installing Front Brake Disc (PCCB)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Always replace the brake calliper fastening screws following removal!
Do not confuse right and left brake discs during assembly!
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Clean the levelling and centering surfaces on the brake disc and wheel hub.
- Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
- Installation is performed in reverse order.
Observe specified tightening torques:
Brake disc to wheel hub: Tightening Torque 15 Nm (11 ft. lb.)
Brake calliper to wheel bearing housing: Tightening Torque 140 Nm (104 ft. lb.)
Brake hose bracket to wheel carrier: Tightening Torque 9 Nm (6.5 ft. lb.)
Cable holder to wheel carrier: Tightening Torque 20 Nm (15 ft. lb.)