LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (46 Brakes - Brake Mechanism -- 92A Cayenne) >> WM 461019 Removing And Installing Mounting Saddle >> Removing Mounting Saddle

Removing Mounting Saddle

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Mounting Saddle Installation Position
G09937218Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Remove relay carrier at the right -2-  next to the brake pedal.
    Fig 2: Removing Relay Carrier
    G09937219Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 1.1. Remove fastening screw -1-  for the relay carrier -2-  at the right next to the brake pedal.
    2. 1.2. Pull the relay carrier down and to the rear -A-  and remove it from the lower guide.
    3. 1.3. Pull the upper guide -3-  for the relay carrier up -B-  out of the bracket -4-  on the mounting saddle.
  2. Remove fastening nuts -1-  for the brake booster under the dashboard.
    Fig 3: Identifying Brake Booster Nuts
    G09937220Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Unclip cable duct cover from main wire harness against the direction of travel -arrow-  and cut the tie-wraps (three in cable duct and three on the left of the cable duct).
    Fig 4: Opening Cable Duct
    G09937221Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Unclip fixing clips -1-  for the cable duct -2-  on the mounting saddle using a suitable tool, e.g. pointed-nose pliers.
    Fig 5: Identifying Clips On Cable Duct
    G09937222Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Unscrew the top fastening screws -1-  for the mounting saddle in the plenum panel.
    Fig 6: Identifying Mounting Saddle Screws (Top)
    G09937223Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Unscrew fastening screw -1-  for the mounting saddle at the bottom of the plenum panel, under the brake booster.
    Fig 7: Identifying Mounting Saddle Screw In Plenum Panel (Bottom)
    G09937224Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Unscrew fastening screws -1-  for the heat shield -2-  at the left of the primary catalytic converter on the longitudinal member.
    Fig 8: Identifying Heat Shield Fastening Screws, Left
    G09937225Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  8. Unscrew the bottom fastening screw -1-  for the mounting saddle through the opening in the wheel housing.
    Fig 9: Identifying Mounting Saddle Screw At Bottom
    G09937226Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  9. Remove mounting saddle from the vehicle.
scientia non olet · About LEMON Manuals