Installing Mounting Saddle

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Fit mounting saddle in the vehicle.
Tighten fastening screws -1- at the bottom. Tightening Torque 23 Nm (17 ft. lb.) +/-3 Nm (+/-2 ft. lb.)

Fig 1: Identifying Screw For Mounting Saddle At Bottom
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws -1- for the heat shield -2- at the left of the longitudinal member. Tightening Torque 2 Nm (1.5 ft. lb.)

Fig 2: Identifying Heat Shield, Left
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screw -1- for the mounting saddle at the left under the brake booster. Tightening Torque 23 Nm (17 ft. lb.) +/-3 Nm (+/-2 ft. lb.)

Fig 3: Identifying Mounting Saddle Screw In Plenum Panel At Bottom
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten the top fastening screws -1- for the mounting saddle in the plenum panel. Tightening Torque 23 Nm (17 ft. lb.) +/-3 Nm (+/-2 ft. lb.)

Fig 4: Identifying Mounting Saddle Screws At Top
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pre-fit tie-wraps -1- in the cable duct -2- .

Fig 5: Identifying Pre-Fitting Tie-Wraps In Cable Duct
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip in fixing clips -1- from the cable duct -2- at the mounting saddle.

Fig 6: Identifying Cable Duct Clips
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure main wire harness in the cable duct and clip in cover.

Fig 7: Identifying Main Wire Harness In Cable Duct
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure main wire harness on the cable duct.

Fig 8: Identifying Main Wire Harness On Cable Duct
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten the fastening nuts -1- for the brake booster under the dashboard. Tightening Torque 26 Nm (19 ft. lb.) +/-3 Nm (+/-2 ft. lb.)

Fig 9: Identifying Brake Booster Fastening Nuts
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit the relay carrier.

Fig 10: Fitting Relay Carrier At Right
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 11.1. Insert the guide -3- for the relay carrier at the right next to the brake pedal from above -B- and into the holder -4- .
2. 11.2. Press the relay carrier -2- down into the guide -A- .
3. 11.3. Fit fastening screw -1- .