LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (48 - Steering -- 92A Cayenne) >> WM 489819 Removing And Installing Hydraulic Pump (Hybrid) (Cayenne S Hybrid) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Risk of material damage if too much Pentosin is used or if Pentosin gets onto the coolant hoses when filling or topping up.
  • Observe the following specifications in order to avoid overfilling and thus overflowing.
  • Before checking the fluid level, run the engine for approx. 20 seconds. Multiple steering operations (maneuvering) will change the fluid level in the reservoir! Check the fluid level.
  • If coolant hoses come into contact with Pentosin, clean them thoroughly with water IMMEDIATELY.
  • Replace visibly swollen coolant hoses.
  1. Raise the vehicle at the prescribed jacking points. → 4X00IN LIFTING THE VEHICLE
  2. Remove front left wheel housing liner. → 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER
  3. Remove the front left wheel. → 440519 REMOVING AND INSTALLING WHEEL