Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

When topping up or filling in Pentosin, make sure that it does not come into contact with the coolant hoses. To avoid overflow caused by overfilling, observe the instructions under → 4890IN TEST AND ASSEMBLY WORK ON POWER STEERING .
If coolant hoses come into contact with Pentosin, clean them thoroughly with water IMMEDIATELY!
Replace visibly swollen coolant hoses.

Fit engine guard → 108019 REMOVING AND INSTALLING ENGINE GUARD .
Fit wheel housing liner → 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER .
Fit wheel → 440519 REMOVING AND INSTALLING WHEEL .
After fitting the pressure lines, fill steering hydraulics with Pentosin CHF 202 and bleed the steering system → 4890IN TEST AND ASSEMBLY WORK ON POWER STEERING .
Adjust toe-in and read and follow information about steering-gear center position! → 449503 SUSPENSION ALIGNMENT, COMPLETE .
Calibrate steering-angle sensor → 456005 INITIALIZING AND CALIBRATING STEERING-ANGLE SENSOR .