LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (48 - Steering -- 92A Cayenne) >> WM 480855 Replacing ELV Control Unit (Except Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne S Diesel, Cayenne (3.0)) >> Teaching ELV Control Unit

Teaching ELV Control Unit

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Voltage drop
  • Risk of irreparable damage to control unit
  • Risk of damage to control unit
  • Fault entries in the control unit
  • Coding in the control unit is aborted
  • Malfunctions in control unit, even during programming

→ Prior to disconnecting the control unit, switch off ignition and remove ignition key.

→ Ensure that the power supply is not interrupted during programming.

→ Connect a battery charger with a current rating of at least → Nominal value: 40 A  to the vehicle battery.

Information 

The PIWIS Tester II 9818  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms; different text or additions may appear in PIWIS Tester II 9818  .

Information 

All remote controls (keys) are required for teaching a DME, front-end electronics (front BCM), rear-end electronics (rear BCM), electronic steering lock (ELV) control unit or remote controls (keys) for example.

Remote controls (keys) that are not taught during this teaching procedure will no longer be recognized by the vehicle.

  1. Switch off ignition and replace the ELV control unit. → 480819 REMOVING AND INSTALLING ELV CONTROL UNIT .
  2. PIWIS Tester II 9818  must be connected to the vehicle before starting the System Tester. Switch on ignition using original remote control.
  3. Select the Online teaching function  menu on the Start page.
  4. Select Vehicle  and press [>>]. Vehicle data will be read out.
  5. The vehicle identification number (VIN) is displayed. Adapt the vehicle identification number if necessary.
  6. Enter the repair order number and press [>>].
  7. Enter the PPN user name and password and press [>>].
  8. Login is performed.
  9. The Tester displays the message Login successful  . Press [>>].
  10. Follow the instructions on the Tester to select the required menu.
  11. Once the teaching process is completed successfully, the Tester shows the following status, for example:

    2 keys taught

    Front BCM: taught

    ELV: taught

    Rear BCM: taught

    DME: taught

    Overall vehicle status: taught

  12. [>>].
  13. Press [EXIT] to exit the Online teaching function  and select the vehicle type  on the Start page.
  14. Press [F7] Read all fault memories and erase if required  and delete all faults.
  15. Lock, open and start the vehicle using all remote controls.
  16. Read out the fault memory again.
scientia non olet · About LEMON Manuals