Teaching While Driving
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
A procedure in PIWIS Tester II 9818 can be used to teach the wheel IDs while driving: >>Tyre Pressure Monitoring (TPM) system << >>Maintenance/repairs<< >>Teach wheel IDs<< >>Teach wheel IDs while driving<<.
The wheel IDs can also be taught without using the System Tester.
The following points must always be observed:
- Allow an idle time of at least 5 minutes before teaching the wheel IDs (wheel electronics units are then in Sleep mode).
- Briefly accelerate the vehicle to over 25 km/h (15 mph) in order to teach the wheel IDs (wheel electronics units are then in Burst mode).
- Then continue driving at any speed (even < 25 km/h or 15 mph) for max. 10 minutes.
- Teaching was successful if a pressure reading is displayed in the instrument cluster for all wheel positions.