Installing Headliner

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Make sure that the roof cover does not buckle.

Guide in the headliner -1- .
1. 1.1. Slide the headliner into the vehicle through the cut-out in the rear lid -B- .
2. 1.2. Lower the headliner -1- on the passenger's side down as far as possible -A- .
  
  Fig 1: Installing Headliner
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Carefully press roof lining down and clip electric line -1- into the bracket -2- .

Fig 2: Clipping Electric Line
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position the headliner on the roof of the vehicle and clip in the fixing clips -3- at the rear by pressing them.

Fig 3: Identifying Clips Of Rear Roof Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check the fixing clips on the headliner close to the sliding-roof cut-out for deformation and replace them if necessary.
Clip in the headliner close to the sliding-roof cut-out using the fixing clips (only on vehicles with a sliding roof).

Fig 4: Clipping Headliner At Sunroof
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in screws -1- on bracket for luggage net cover at the sides and tighten to Tightening torque 9 Nm (6.5 ftlb.) .

Fig 5: Identifying Screws Of Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in screws -2- on bracket for luggage net cover for rear luggage compartment and tighten to Tightening torque 9 Nm (6.5 ftlb.) .

Fig 6: Identifying Screws On Bracket For Rear Luggage Net Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in screws for the headliner under the roof console -1- .

Fig 7: Identifying Roof Console
Courtesy of PORSCHE CARS NORTH AMERICA, INC.