Installing Rear Door Panel
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Porsche Cayenne, 2017 Porsche Cayenne, 2016 Porsche Cayenne, 2015 Porsche Cayenne, and 2014 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
Only for vehicles with "Electric sun blind for rear side windows"
- The push rod cannot be disassembled .
- Make sure that the push rod is not kinked during removal and installation .
- During installation, make sure that the push rod engages correctly in the drive mechanism for the sun blind .
- The rear door panel is installed in reverse order to removal.
- On vehicles with sun blind
- 2.1. To install the door panel, pull the sun blind up completely and guide the push rod into the guide tube on the bare door shell.
- Tighten fastening screws for top of door panel to Tightening torque 4.5 Nm (3.5 ftlb.) .
- Tighten fastening screw for bottom of door panel to Tightening torque 2 Nm (1.5 ftlb.) .