| Intake-air distributor to cylinder head |
External Torx screw, M6 x 35 |
Tightening torque |
13 Nm (9.5 ftlb.) |
|
|
| Clamp securing upper part of resonance tube to lower part |
Internal Torx screw, M6 x 35 - micro-self-locking - replace screws |
Tightening torque |
4.5 Nm (3 ftlb.) |
|
|
| Positive crankcase ventilation holder to intake-air distributor |
External Torx screw, M6 x 12 (2x) |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Vacuum unit to resonance tube |
Self-tapping screw |
Tightening torque |
5 Nm (3.5 ftlb.) |
|
|
| Tank vent valve holder to intake-air distributor |
External Torx screw, M6 x 12 (2x) |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Intake manifold pressure sensor to intake-air distributor |
Oval-head screw, 6.0 x 15 |
Tightening torque |
5 Nm (3.5 ftlb.) |
|
|
| Throttle housing to intake-air distributor |
External Torx screw, M6 x 50 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Rubber sleeve for air intake |
Screw-type clamp |
Tightening torque |
3 Nm (2 ftlb.) |
|
|
| Cable duct to intake-air distributor |
External Torx screw, M6 x 16 |
Tightening torque |
13 Nm (9.5 ftlb.) |
|
|
| Air cleaner housing to body |
Fastening nut |
Tightening torque |
4 Nm (3 ftlb.) |
|
|