LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> 2X - Petrol, Exhaust, Engine-Electronic - General -- (981) BOXSTER/CAYMAN >> WM 2X00IN Important Information On Adapting The DME Control Unit (Except BOXSTER SPYDER) >> Writing Adaptation Values (Following Deletion) >> Sensor Wheel Adaptation

Sensor Wheel Adaptation

Necessary after: 

Necessary before: 

How? 

  1. Drive with engine overrun:
    1. 1.1. Meet preconditions:
      1. 1.1.1. Engine at operating temperature.
    2. 1.2. Accelerate to 3, 000 RPM (U/Min ) three times in quick succession in 2nd gear and allow vehicle to roll with gear engaged (engine overrun).

      Information 

      1. Adaptation values are deleted or stored in EEPROM when ignition is switched off after control unit run-on has ended.

      This depends on the run-on period of the engine compartment purge fan.

      The run-on period of the engine compartment purge fan AFTER ignition is switched off depends on the engine compartment temperature.

      The run-on period is as follows at the following engine compartment temperatures:

      • < 45 °C: approx. 50 seconds 
      • 45... 70 °C: approx. 200 seconds 
      • > 70 °C: up to 20 minutes 
    3. 1.3. Switch off ignition.
scientia non olet · About LEMON Manuals