Removing Dashboard Bracket
- Disconnect wire harness for dashboard.
- 1.1. Disconnect plug connection for dashboard at connection point on left A-pillar.
- 1.1.1. Release plug connections at the left fuse box -A- and remove them -B- .
- 1.1.2. Release plug connections -a- and pull them off -C- .
- 1.2. Unclip fixing clips -1-
for wire harness at the heating/fresh-air unit.
- 1.3. Disconnect plug connection for dashboard at connection point on right A-pillar.
- 1.3.1. Release plug connections at the left fuse box -A- and remove them -B- .
- 1.3.2. Release plug connections for the dashboard wire harness -a- and pull them off -C- .
- 1.4. Disconnect plug connection for blower power supply.
- 1.5. Release plug connection -A- and disconnect it -B- from the heating/fresh-air unit.
- 1.6. Release plug connection at the two locking lugs -a- and pull it off -C- .
- 1.1. Disconnect plug connection for dashboard at connection point on left A-pillar.
- Loosen mounting for dashboard bracket.
- 2.1. Unscrew fastening nuts -1-
for the heating/fresh-air unit.
- 2.2. Unscrew the bottom fastening screw at the right on the tunnel -2-
.
- 2.3. Unscrew the outer fastening screw -3- .
- 2.4. Unscrew the fastening nuts at the sides -1- .
- 2.5. Remove bracket for dashboard from the body.
- 2.6. Unclip electric lines -1-
on the right side of the dashboard bracket -2-
.
- 2.7. Swivel the dashboard bracket out towards the passenger compartment.
- 2.1. Unscrew fastening nuts -1-
for the heating/fresh-air unit.