Removing Longitudinal Member For Wheel Housing Upper Section

Fig 1: Wheel Housing Upper Section Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of longitudinal member for wheel housing upper section

1. Remove bracket for longitudinal member for wheel housing.

   Information 

   Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

   1. 1.1 Drill out spotwelds. > Nr.129 - Spotweld drill bit  > VAS 882 001 - Spot-weld remover 

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bracket for longitudinal member for wheel housing

2. Heat bonding areas of bracket for longitudinal member for wheel housing.
   1. 2.1 Remove bracket for longitudinal member for wheel housing.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Bracket for longitudinal member for wheel housing

3. Drill through punch rivets on upper longitudinal member plate -1-  using a > Nr.201 - twist drill  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing upper longitudinal member

4. Heat bonding areas of upper longitudinal member -1-  .
   1. 4.1 Remove upper longitudinal member.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Heating bonding areas

5. Drill through punch rivets on the outer upper longitudinal member using a > Nr.201 - twist drill  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Outer upper longitudinal member

6. Heat bonding areas of outer upper longitudinal member.
   1. 6.1 Remove outer upper longitudinal member.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas