Removing Cover For Front Backrest
- Mask the backrest shell -1- in the marked area with adhesive tape -2- (2-3 layers).
- Disconnect plug connection for height adjuster.
- 2.1. Disconnect plug connection -1- .
- 2.2. Unclip line -arrows- .
- Unclip height adjustment switch -2- (-arrow- ) and remove it.
- Unclip trims -1- (-arrows- ).
- Detach cover.
- 5.1. Pull off cover -2- at the Velcro fasteners -1- all the way around -arrows- .
- 5.2. Disengage reinforcement -3- in the side airbag area from the bracket -4- (-arrow A- ).
- Press seat cover -1- down over the side cushion -arrows A- and disengage it at the seat shell -arrows B- .
- Remove mounting for belt feed-through element.
- 7.1. Pull off felt adhesive tape -1- .
- 7.2. Unscrew fastening nut -2- .
- Remove seat cover -1-
in the belt feed-through element area -arrows-
.
To do this, pull the bowden cable out of the seat cover. This must be replaced following removal.
- Press seat cover -1- down over the side cushion -arrows A- and disengage it at the seat shell -arrows B- .
- Remove padding -1- (-arrow- ).
- Remove cover.
- 11.1. Unclip plastic rivets -1- .
- 11.2. Remove reinforcement -2- with backrest cover -3- from the seat shell -4- (-arrow- ).