Test Values/Wear Limits For 911 Turbo/GT3/GT3 RS - PCCB Brakes (Option)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
The following condition criteria can make replacement necessary depending on the wear of the PCCB brake discs:
- Surface changes in the brake disc friction surfaces at an advanced stage.
- Minimum brake disc thickness is not retained due to wear (material erosion due to friction).
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Pad thickness, front | Measured value | approx. 12.0 mm | |||
| Pad thickness, front (wear limit) | Measured value | 2 mm | |||
| Pad thickness, rear | Measured value | approx. 12.0 mm | |||
| Pad thickness, rear (wear limit) | Measured value | 2 mm | |||
| Brake disc thickness, new (front) | Measured value | 34 mm | |||
| Brake disc thickness, new (rear) | Measured value | 28 mm | |||
| Brake disc wear limit, front | Minimum brake disc thickness (wear limit) is stamped on the brake-disc chamber. Example: Min. Th. 33.7 mm | Measured value | mm (Read value on brake-disc chamber) X.XX | ||
| Brake disc wear limit, rear | Minimum brake disc thickness (wear limit) is stamped on the brake-disc chamber. Example: Min. Th. 27.7 mm | Measured value | mm (Read value on brake-disc chamber) X.XX | ||
| Wear limit: Surface changes in front and rear brake discs | Wear limit: Connected surface fracture > 1 cm2 and/or surface roughness of brake disc > 80 micrometer. Replace PCCB brake discs on each axle. | Surface changes | Values and procedure for: checking front 46 51 02 PCCB brake discs/checking rear 46 54 02 PCCB brake discs. | ||
| Thickness tolerance of brake discs (max.) | Measured value | 0.02 mm | |||
| Lateral runout of brake disc (max.) | Measured value | 0.03 mm | |||
| Lateral runout of wheel hub (max.) | Measured value | 0.03 mm | |||
| Lateral runout of brake disc when installed (max.) | Measured value | 0.06 mm | |||
| Pushrod play | Measured at brake pedal plate | Measured value | approx. 1 mm | ||
| Diameter of parking-brake drum | Parking brake/hand brake (drum brake acting mechanically on both rear wheels) | Diameter | 180 mm | ||
| Diameter of parking-brake drum, wear limit | Diameter | 181 mm | |||
| Width of parking-brake shoe | Measured value | 25 mm | |||
| Thickness of parking-brake pad | Measured value | 4.5 mm | |||
| Thickness of parking-brake pad, wear limit | Measured value | 2 mm |