LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (66 - Exterior Equipment -- 911 CARRERA (991)) >> WM 663519 Removing And Installing Trim Panel For TARGA Bar (TARGA 4, TARGA 4S, TARGA 4 GTS) >> Installing Trim Panel For Targa Bar

Installing Trim Panel For Targa Bar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. The side trim panel is installed without the assembly clip. 
  2. Installation is performed in reverse order to removal.
  3. Position side trim panel at the previously marked areas and tighten fastening screw to.
  4. Position side trim panel at the previously marked area and tighten fastening nuts to.
  5. Position trim panel flaps at the previously marked area and tighten fastening screws to.
  6. Position center trim panel at the previously marked area and tighten fastening screws to.
  7. Adjust gap dimensions of the trim panel if necessary. → 663515 ADJUSTING TRIM PANEL FOR TARGA BAR 
scientia non olet · About LEMON Manuals