LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove axle nut (securing drive shaft to wheel bearing housing). Also press the brake (2nd mechanic required) while the vehicle is stationary on the ground.
  2. Raise the vehicle.

    → 4X00IN LIFTING THE VEHICLE .

  3. Remove wheel.

    → 440519 REMOVING AND INSTALLING WHEEL .

  4. Release the parking brake. Switch off ignition.
  5. Remove the brake calliper from the wheel bearing housing (do not open the brake system) and suspend it in the wheel arch.

    To do this, disconnect electric connector on combination wire for ABS and brake pad wear indicator and remove retaining plate from the wheel bearing housing.

    → 474119 REMOVING AND INSTALLING REAR BRAKE CALLIPER .

scientia non olet · About LEMON Manuals