Installing KESSY/PAS control unit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Voltage peaks

Risk of damage to load or to the control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

NOTE: Voltage peaks

Risk of damage to load or to the control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

Information

Depending on the vehicle equipment, the control unit has one or two connectors.

Press both electrical connectors -1, 2- into the control unit and lock them until they are felt to engage.

Fig 1: Installing Electrical Connectors
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Engage control unit in support for wiring harness with both retaining lugs.

Fig 2: Installing Control Units
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Clip in control unit on the support for the steering wiring and engage the locking mechanism for the lock.

Fig 3: Installing Control Unit And Pivoting Out Securing Bolt
Courtesy of PORSCHE CARS NORTH AMERICA, INC.