Installing Gas-Discharge Control Unit

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Push on electric connector -4- for the gas-discharge control unit until the connector engages securely.

Fig 1: Connecting Electric Plug
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert the control unit into the lid of the headlight and secure with the fastening screw -3- .

Fig 2: Screwing In Fastening Screw For Control Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the gas-discharge headlight cable into the terminal in the lid.

Fig 3: Pressing In Gas-Discharge Headlight Cable
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide on the coil and screw in the fastening screws for the coil -2- and cable holder -1- .

Fig 4: Sliding On Coil And Screwing In Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.