Subsequent Work For Removing And Installing Hydraulic Pump (Pdcc)
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
Pentosin in engine compartment
- The reservoir is located in the engine compartment, at the front left.
- A dipstick with MAX/MIN markings is mounted on the cap of the reservoir. They are for a fluid level with a cold engine (approx. 20°C).
- The MAX marking can be easily exceeded at higher temperatures.
- Check the fluid level (Pentosin CHF 202) with the engine switched off and cold (approx. 20°C).
- Install air cleaner housing.
> 242519 Removing and installing air cleaner housing - section on "INSTALLING "
- Fit the air box for the throttle housing (Y-shaped pipe).
> 243519 Removing and installing air box for throttle housing (Y-shaped pipe) - section on "INSTALLING "
- Fit wheel housing liner.
> 505619 Removing and installing front wheel housing liner - section on "INSTALLING "
- Fit engine guard.
> 108019 Removing and installing engine guard - section on "INSTALLING "
- Fit the left front wheel.
> 440519 Removing and installing wheel - section on "INSTALLING "
- Fill the reservoir and do not exceed the MAX marking.
- Bleed the PDCC and hydraulic power-steering system.