Removing And Installing Rear Brake Disc (Pccb)

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: NOTIFICATION
Removing/fitting wheels

Risk of damage to (ceramic) brake discs
1. Carefully guide the wheel towards the wheel hub, thereby preventing any heavy impact on the (ceramic) brake disc.

> 9818 - PIWIS Tester II must be connected and started.
1. 1.1 Select parking brake.
2. 1.2 Select Maintenance/repair.
3. 1.3 Move to installation position.
Release and unclip connector for the brake pad wear indicator and remove it from the holder -arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unclipping cable
NOTE:
NOTIFICATION
Removal of brake calliper
- Paint defects on brake calliper
  1. Proceed with care when setting back the brake pads.
  2. Protect brake calliper from paint defects using a suitable cloth.
Set the brake pads back slightly and evenly using water pump pliers.
Detach the brake calliper on the wheel carrier and suspend it at a suitable place in the wheel housing or set it down carefully (do not open the brake hydraulic system!).
> 474119 REMOVING AND INSTALLING REAR BRAKE CALLIPER (PCCB)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing brake calliper (shown as an example)
Unscrew fastening screw -B- and remove brake disc.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Brake disc (shown as an example)