Installing Rear Brake Disc (Pccb)
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Brake calliper screws can always be re-used if no damage can be identified.
- Replace damaged bolts.
- Observe different tightening specifications!
Do not confuse right and left brake discs during assembly!
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Clean the levelling and centering surfaces on the brake disc and wheel hub.
- Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
- Installation is performed in reverse order
Observe specified tightening torques:
Brake disc to wheel hub: > Tightening torque 15 (11 ftlb.) Nm
Brake calliper to wheel bearing housing: > Tightening torque 85 Nm (63 ftlb.)
Cable holder to wheel bearing housing: > Tightening torque 8 (6 ftlb.) Nm
- Connect and start the Porsche System Tester.
- 5.1 Adjust and calibrate the parking-brake shoes.
- Position disc brake pads by operating the brake several times.
- Check the brake fluid level and correct it if necessary.