LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 427137 Disassembling And Assembling Rear Spring Strut (Steel Springs) >> Information >> Component Overview

Component Overview

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

The steel springs do not apply for the Cayenne Turbo.

Standard Cayenne Turbo equipment: Air springs with level control and vertical adjustment.

G16329932Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Steel spring strut, complete (shown with PASM)

Fig 1: Exploded View Of Steel Spring Strut (Shown With PASM)
G16329933Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Exploded view of steel spring strut (shown with PASM)

No. Designation Note
-1-  Connector housing Only for PASM (Porsche Active Suspension Management)
-2-  Grommet
(connector)
Only for PASM
-3-  Grommet (cable) Only for PASM
-4-  Cable guide Only for PASM
-5-  Hexagon nut (4x) Use new hexagon nuts.
-6-  Cable holder
(rubber)
Only for PASM
-7-  Cover Allocation of cover as per Parts Information.
-8-  Lock nut Use a new lock nut.
-9-  Supporting mount Allocation of supporting mount as per Parts Information.
-10-  Concave support
-11-  Top support Fit together at the correct position with top base. (Align triangular markings all the way around).
-12-  Top base Fit together at the correct position with top support. (Align triangular markings all the way around).
-13-  Boot
-14-  Rubber stop Allocation of rubber stop as per Parts Information.
-15-  Washer No longer used from model year B onwards.
Allocation of washer as per Parts Information.
-16-  Cap Allocation of cap as per Parts Information.
-17-  Coil spring Allocation of coil spring as per Parts Information.
-18-  Bottom base Fit together at the correct position with bottom support. (Align triangular markings all the way around).
-19-  Bottom support Fit together at the correct position with bottom base. (Align triangular markings all the way around).
-20-  Spacer Number of spacers depends on the tolerance class (0 spacers, 1 spacer or 2 spacers).
The number depends on the number of violet dots on the coil spring.
> -21-  Concave washer
> -22-  Shock absorber Allocation of shock absorber as per Parts Information.