LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (15 - Engine - Cylinder Head, Valve Drive (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 153719 Removing And Installing Solenoid/Hydraulic Valve For Camshaft Adjuster >> Removing Solenoid/Hydraulic Valve For Camshaft Adjuster

Removing Solenoid/Hydraulic Valve For Camshaft Adjuster

WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unscrew fastening screws for hydraulic valve -4-  .
  2. Carefully pull the hydraulic valve -3-  up and out. To do this, use > 9235 - relay puller. Hold hydraulic valve only at the metal insert.
    Fig 1: Camshaft Adjustment Components Location
    G16308577Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Camshaft adjustment

    1  Screw, M12 Tighten fully after setting timing.  ; Screw must be replaced.
    2  Camshaft adjuster with integrated hexagon for countering
    3  Hydraulic valve for camshaft control
    4  Screw, M5 x 12
  3. Inspect strainer of hydraulic valve and clean with solvent naphtha if necessary. Replace hydraulic valve if heavily soiled.
scientia non olet · About LEMON Manuals