| No. 1: Threaded connection securing steering wheel to steering column |
M18 x 1.5 x 26 thread (only use screw once) |
Tightening torque + torque angle |
30 Nm (22 ftlb.) |
+90° |
|
| No. 3: Threaded connection securing steering column to assembly bracket |
M8 x 32 thread; observe tightening sequence! Tighten anti-clockwise from 1 to 4, starting with the rear right fastening screw. |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| No. 4: Threaded connection securing steering column to frequency strut |
M8 x 115 thread; screw frequency strut to mounting bracket after screwing on steering column! |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| No. 5: Threaded connection securing mount for sealing ring/seal to firewall |
|
Tightening torque |
4 Nm (3 ftlb.) |
|
|
| No. 6: Threaded connection securing universal joint to steering gear |
M8 x 30 thread (only use screw once) |
Tightening torque |
20 Nm (15 ftlb.) |
+90° |
|