Removing Charge-Air Cooler

Charge-air cooler, left:
1. 1.1. Unclip holder -1- for vacuum hose. Disregard item 2.
2. 1.2. Remove boost pressure sensor for cylinder bank 2. → 219019 REMOVING AND INSTALLING BOOST PRESSURE SENSOR
  
  Fig 1: Unclipping Vacuum Hose
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Charge-air cooler, right:
1. 2.1. Remove throttle housing unit. → 244219 REMOVING AND INSTALLING THROTTLE HOUSING
2. 2.2. Remove boost pressure sensor. → 219019 REMOVING AND INSTALLING BOOST PRESSURE SENSOR
Continue as follows for both sides:
Unscrew screws -1- and -2- and remove coolant pipes on the compressor.

Fig 2: Identifying Coolant Pipes On Charge-Air Cooler
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew screws -1, 2- for left charge-air cooler and -3, 4- for right charge-air cooler.

Fig 3: Identifying Screws Of Charge-Air Cooler
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information
- Coat seals on the charge-air cooler with engine oil through the intake-air openings .
Levering Device 2036 with -2036/1- must be secured on the compressor as shown.
Fit socket-wrench insert (a/f 32) at the front of the charge-air cooler.

Push the charge-air cooler slowly and with moderate force to the rear out of the compressor housing using a levering device.

Fig 4: Removing Charge-Air Cooler
Courtesy of PORSCHE CARS NORTH AMERICA, INC.