Removing Roof Console

→ Switch off ignition and remove remote control before disconnecting or removing load.

Information 

Always comply with the regulations for handling ESD-sensitive components!

• Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche  .
• The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed  .
• Never touch the electric pins and plug contacts  .

1. Switch off ignition and remove remote control (hand-held transmitter).
2. Unclip trim for headliner.
   Fig 1: Unclipping Trim

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Unclip headliner at the two side cut-outs -A-  and swivel it downwards -B-  .
   Fig 2: Unclipping Headliner

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Lift headliner off towards the rear.
   Fig 3: Lifting Off Headliner

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Disconnect wire harness.
   Fig 4: Disconnecting Wire Harness

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 5.1. Release plug connections -a-  and disconnect them -B-  .
   2. 5.2. Unclip fastening clip for wire harness -C-  .