Installing Front Brake Disc (PCCB)

Information 

• Always replace the brake calliper fastening screws following removal! 

Do not confuse right and left brake discs during assembly!

1. Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
2. Clean the levelling and centering surfaces on the brake disc and wheel hub.
3. Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
4. Installation is performed in reverse order.

   Observe specified tightening torques:

   Brake disc to wheel hub:

   Brake calliper to wheel bearing housing:

   Brake hose bracket to wheel carrier:

   Cable holder to wheel carrier: