Removing Gateway Control Unit

Information 

Always comply with the regulations for handling ESD-sensitive components!

• Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche  .
• The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed  .
• Never touch the electric pins and plug contacts  .
  Fig 1: Identifying Gateway Control Unit Installation Position

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Unscrew fastening screws -1-  .
   Fig 2: Removing Control Unit Holder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Remove holder with control units -arrow A-  and set them down in the footwell.
3. Release electric plug connection -a-  and disconnect it from the control unit.
   Fig 3: Disconnecting Connector For Gateway Control Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Unscrew fastening screws -2-  on the back of the gateway control unit.
   Fig 4: Removing Gateway Control Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Remove control unit.