Installing cover for the seat cushion.

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Cover For Seat Cushion

Courtesy of PORSCHE OF NORTH AMERICA, INC.

SEAT CUSHION COVER INSTALLING PROCEDURE

No.	Procedure	Instructions
1	Mounting the seat cover on to the foam part (seat cushion)	Position seat cover covering strips -C-A-D-E-B-A (seat cushion). See Fig 1 .
2	Mounting the seat cover on to the cushion carrier	Note: The plastic clips -4-4-E- . See Fig 1 .
3	Fitting seat cover onto the cushion carrier	Fit the seat cover over the foam part so that it is free from wrinkles. Push the push-on bead -3-1-2- . See Fig 1 .
	Installing cushion carrier	See INSTALLING FRONT CUSHION CARRIER .
CAUTION: Danger of material damage if excessive heat is applied! If creases form, only short partial warming with the hot-air gun is permissible. Always observe the hot-air temperature of approx. 50 degrees Celsius (122 Fahrenheit).
	Remedying creases in the backrest cover	If creases form in the areas of the backrest cover, heat them partially with the hot-air gun.